top of page

Cable Drop
PC-FW

PC-FW.png

Application

The Cable Drop may be used to supply power from the Plug-N-Go flexible wiring system to lighting fixtures or electrical receptacles required as part of the local circuit. Cable Drop components may also be used as an alternative to the Plug-N-Go Fixture Connector (PC-FS) or to transition from the flexible wiring system back to conventional wiring methods.

Features

  • Easily installed

  • Full 20 amp rating

  • Single, dual and three circuit models

  • #12 AWG copper conductors standard

  • #10 AWG copper conductors optional

  • 600V, 90º C insulation

  • Dead front construction for safety

  • Connectors are color coded for easy voltage identification

  • Keyed components assure proper connection, function and safety

  • Positive locking clips prevent accidental disconnection

  • Approved for installation in air handling spaces other than ducts and plenums

  • UL listed

Specifications

Additional Information

  • The Cable Drop component consists of a female connector and a length of flexible armor cable with stripped pigtail leads for easy installation. All connectors are color coded for easy voltage identification and are keyed to allow mating connections only with components of the same voltage. Secure connections are assured by locking clips on the component rear cup assemblies which prevent accidental disconnection. Cable length is based on project requirements.

  • The Cable Drop component may be used to supply power from the Plug-N-Go flexible wiring system to lighting fixtures or electrical receptacles required as part of the local circuit. Cable Drop components may also be used as an alternative to the Plug-N-Go Fixture Connector (PC-FS) or to transition from the flexible wiring system back to conventional wiring methods.

  • Cable Drop components install in standard junction boxes (by others). Cable Drop components are designed to install in any junction box with a 1/2" knockout and secure in place by means of a locknut supplied with the connector. The size of the junction box is determined by the number and size of conductors within the box as determined by the NEC. Electrical connections are made to the Cable Drop's pigtail leads using appropriate connectors according to the requirements of the installation.

    ​

    NOTE: Cable Drop components are manufactured using type MC cable with #12 AWG copper conductors and 90°C insulation and should be supported in accordance with National Electrical Code requirements.

  • Connector Color → Voltage

    Gray → 277/480 and 480VAC

    Brown →120/208, 208 and 240VAC

    Purple → Dual Neutral 120/208VAC

    Khaki → Dual Neutral 277/480VAC

    Green → Isolated Ground 120/208VAC

bottom of page