Products for Commercial Applications

The Switch Module accepts incoming unswitched power and provides both a switched and an unswitched output connector.

Designed to increase the length of any Plug-N-Go cable. Extender Cables are also used to distribute power between Plug-N-Go Switch Modules in all switching applications.

Splitter Modules split single, dual or three circuit sources of switched or unswitched power into two output connectors.

Used for the distribution of branch circuits to power fluorescent or HID luminaires. 

Provides the interface between the hard wiring from the distribution panel and the Plug-N-Go flexible wiring system components.

Provides an alternative to Distribution Box Connectors and Extender Cables when wiring local switching functions. Distribution Box Cables install into standard junction boxes (by others) by means of a standard cable connector.

Designed to connect to junction boxes and introduce power to the first lighting fixture on a run and continue AC power connections to the remaining fixtures on the circuit

Designed to introduce power to the lighting fixture to which it is installed and to continue AC power connections to the remaining fixtures on the circuit.

Used to supply power from the Plug-N-Go flexible wiring system to lighting fixtures or electrical receptacles required as part of the local circuit.

Used to supply power from the Plug-N-Go flexible wiring system to lighting fixtures or electrical receptacles required as part of the local circuit.