Extender Cable PC-E
Features
-
Easily installed
-
Interfaces with all Plug-N-Go components
-
Application versatility
-
Full 20 amp rating
-
Single, dual and three circuit models
-
#12 AWG copper conductors standard
-
#10 AWG copper conductors optional
-
600V, 90º C insulation
-
Dead front construction for safety
-
Connectors are color coded for easy voltage identification
-
Keyed components assure proper connection, function and safety
-
Positive locking clips prevent accidental disconnection
-
Approved for installation in air handling spaces other than ducts and plenums
-
UL listed
Downloads
Application
Industrial Extender Cables are designed to increase the length of any Plug-N-Go cable when required due to last minute project changes or equipment relocations. Extender Cables are also used to distribute power between Plug-N-Go Switch Modules in all switching applications.
Additional Information
The Extender Cable consists of three, four or five #12 AWG copper conductors in a flexible metal jacket with a male line side connector and a female load side connector. Extender Cable connectors provide recessed electrical terminals that result in a dead front design for added safety. All connectors are color coded for easy voltage identification and are keyed to allow mating connections only with components of the same voltage. Secure connections are assured by locking clips on the component rear cup assemblies which prevent accidental disconnection. Cable length is based on project requirements.
The Extender Cable's primary functions are to extend Plug-N-Go cable lengths as required and to carry unswitched power between Switch Modules.
NOTE: Extender Cables are manufactured using type MC cable with #12 AWG copper conductors and 90°C insulation and should be supported in accordance with National Electrical Code requirements.
Connector Color → Voltage
Gray → 277/480 and 480VAC
Brown →120/208, 208 and 240VAC
Purple → Dual Neutral 120/208VAC
Khaki → Dual Neutral 277/480VAC
Green → Isolated Ground